Mivec Owners Group

It is currently 22 May 2018 07:17

All times are UTC + 12 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: MD not engaging
PostPosted: 17 May 2018 22:09 
Offline

Joined: 10 Aug 2014 02:22
Posts: 8
Country: New Zealand
Hi, recently purchased a mivec-md. I have owned one previously. The cylinder is not cutting down to two cylinders at idle, and stays at 1500rpm. When I change gear the revs keep up as well. I've noticed the water temp is quite low and looks like a thermostat problem, but could this cause MD not to engage?


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC + 12 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group