Mivec Owners Group
http://mivec.co.nz/forums/

MD not engaging
http://mivec.co.nz/forums/viewtopic.php?f=7&t=12298
Page 1 of 1

Author:  Jnic0 [ 17 May 2018 22:09 ]
Post subject:  MD not engaging

Hi, recently purchased a mivec-md. I have owned one previously. The cylinder is not cutting down to two cylinders at idle, and stays at 1500rpm. When I change gear the revs keep up as well. I've noticed the water temp is quite low and looks like a thermostat problem, but could this cause MD not to engage?

Author:  LOUKASPAP94 [ 11 Jun 2018 21:02 ]
Post subject:  Re: MD not engaging

You should definitely look out for that, since ive owned a mivec car, i understood one thing, EVERYTHING MATTERS! :lol:
I have an md aswell, 1gen, some times i get high revs for a couple of seconds when i stop, but it falls at the end

Author:  Jnic0 [ 15 Jul 2018 13:40 ]
Post subject:  Re: MD not engaging

I changed the thermostat, it was stuck open. MD still does not engage but i assumed the ecu has been changed out. I owned an MD years back and this one does nothing an MD ecu would do.

Page 1 of 1 All times are UTC + 12 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/