Mivec Owners Group
http://mivec.co.nz/forums/

Cyborg ZR Rev Limit Diagnosis
http://mivec.co.nz/forums/viewtopic.php?f=7&t=12199
Page 2 of 2

Author:  Cameron [ 04 Jan 2018 16:02 ]
Post subject:  Re: Cyborg ZR Rev Limit Diagnosis

Worn cam tray dude, bad news i know been through it so many times, i need to sit down one day and work out where the oil leaks out and how to fix it, finding a good cam tray is near on impossible now, my one in my race car isnt great either but its still ok at the moment :roll:

Author:  ImranNZ [ 04 Jan 2018 18:15 ]
Post subject:  Re: Cyborg ZR Rev Limit Diagnosis

Cheers for the reply man. Good news is that I have two cam trays lol. One from an 85km engine and another from an unknown km engine. I’m a complete novice when it comes to engine diy. Am I correct in assuming the hardest bit would be redoing the engine timing?

Author:  Cameron [ 09 Jan 2018 15:44 ]
Post subject:  Re: Cyborg ZR Rev Limit Diagnosis

Yeah you have it, ideally swap the cam tray and the cams out of that cam tray at the same time as they wear together in the tray.

The cambelt is not hard to do but if you havnt done one before i would get someone who knows to watch over you so you get the timing correct, easiest way is to mark the belt on the 2 cam gears and crank sprocket, then you cant go wrong, i would put a new belt on it and hydro tensioner

Author:  legenddarcy [ 01 Feb 2018 22:22 ]
Post subject:  Re: Cyborg ZR Rev Limit Diagnosis

Any update on this?

Page 2 of 2 All times are UTC + 12 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/