Mivec Owners Group

It is currently 27 May 2018 15:05

All times are UTC + 12 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: 17 Jun 2014 00:39 
Offline

Joined: 17 Jun 2014 00:20
Posts: 4
Country: Trinidad
Hi guys, i recently did a engine swap from a sohc carb 4g15 and tranny to a 4g92 mivec and gearbox in my cb3 lancer, problem my axle dropped out about 3 times already because the axle on the right hand side (when facing the engine bay i.e. longer axle) is about half of an inch short. Due to that the inner cup is now damaged and doesn't go into the box properly, so i put a spacer on the axle, used an old bearing housing and i was going to buy another inner cup, but i wanted to know if that would work or if there are any other axles that would be able to work on the mivec box, everything working with the engine, just the axle problem that has me out of commission now. It has proven difficult to get the 4g92 mivec axles where i live, so any help would be greatly appreciated!!!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC + 12 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group