Mivec Owners Group

It is currently 19 Nov 2018 03:44

All times are UTC + 12 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: 21 May 2014 00:53 
Offline

Joined: 13 Aug 2011 12:33
Posts: 381
Country: ireland
Hi all, ive a crown wheel and output shaft that i want to build custom final drive, they dont match 100% but are very very close, is there any decent companies that would be capable of this work?

I presume U cant tamper with output shaft but crown wheel tooth's could be cut deeper i think, as there more material on the wheel than shaft itself.

Any thoughts?

_________________
....internet....salesmen.....bullshit.....dumb kids.....they all go together.


Top
 Profile  
 
PostPosted: 02 Jun 2014 19:51 
Offline
Moderator
User avatar

Joined: 09 Jun 2004 16:33
Posts: 4460
Location: Auckland
Country: NZ
I'd guess it would be about the same cost to get a new gear cut. They need to be calculated out to get he mesh right and then hardened. The sets I got built were nzd$1500 a single gear was about nzd$300. That was high end alloy to handle evo power levels.

_________________
MIVEC Data | Mitsi's > 96 GSR (stolen) | 97 Evo 4 (sold) | 96 Cyborg-RX (crashed) | 93 Cyborg-R (sold) | 3x Mirage 4WD (sold) | 98 MIVEC Race car (sold)


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC + 12 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group