Mivec Owners Group

It is currently 24 Nov 2020 21:54

All times are UTC + 12 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: 02 Sep 2020 14:08 
Offline

Joined: 22 Feb 2007 02:07
Posts: 17
Location: Trinidad and Tobago
Hey folks, been a LONG time since I've been here. Been working on my old CB1A lancer again so thought I'd pick your brains a bit:

Now I have 4g93t on a F5M22 box, only recently found out to be (AHEM) a student driver lancer specific to Japan.(RRRG). Now when I got the box to do my conversion, I had bought the correct mounts etc for manual. Only thing I did not have, were the axle shafts. But my 1.3 ines fit the supplied inner cups and it worked fine, but had this really bad vibration when locking left. I lived with it till the car was parked in 2012 or so and decided to try and tackle it.

BUT thinking that the main issue waa that my left shaft because it is about 1.5 inches short, there is NO adjustment for the right side. So when it locks over to the left, it bottoms out, causing the vibration.

End to end, the right side is 24" but I do not know any other model that may work, other than the ASA showing the full shafts compatible with the CA4A. And finding anything for this age of car in Tobago is proving impossible and expensive if you have to find anything outside... especially now with covid happening and our customs raising prices exponentially to clear anything.

So hoping someone here has had this issue and had a solution as to what may work. If there is a short shaft that is 23" for the very least, that would be perfect, but I dunno.

Should note that no accidents, mounts even changed to prothane, went from1.3 to to 254mm gsr brakes to 276mm evo ones and still same issues.


Attachments:
File comment: Originally 1.3 Carby Auto
20200402_154852.jpeg
20200402_154852.jpeg [ 612.51 KiB | Viewed 340 times ]
File comment: Now 1800 turbo Manual
20200130_125123-01.jpeg
20200130_125123-01.jpeg [ 696.12 KiB | Viewed 340 times ]
File comment: Left side of 1.3 axle pushed right in to cup (right side cannot even move 3mm)
20200830_092734.jpg
20200830_092734.jpg [ 567.94 KiB | Viewed 340 times ]
File comment: Inside of left side.
20200830_092746.jpg
20200830_092746.jpg [ 614.95 KiB | Viewed 340 times ]
File comment: Short side (Right Side) axle length
20200831_150750.jpg
20200831_150750.jpg [ 475.83 KiB | Viewed 340 times ]
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC + 12 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 11 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group