Mivec Owners Group
http://mivec.co.nz/forums/

pedal box
http://mivec.co.nz/forums/viewtopic.php?f=30&t=11105
Page 1 of 1

Author:  chch_mirage [ 22 Nov 2013 19:32 ]
Post subject:  pedal box

has anyone fitted an aftermarket brake pedal box to there car and got rid of the brake booster
cheers karl

Author:  Sack of Spuds [ 22 Nov 2013 20:35 ]
Post subject:  Re: pedal box

Not yet, though I do have a bias pedalbox to fit. I bought it used so am unsure of its origins but is probably a HHMS one or could be from an EVO as its a direct replacement type not a universal one.

Scroll down for the HHMS one - http://hh-ms.com/parts-catalogue/?SelCa ... tegoryID=3

Pic showing the under bonnet side of an HHMS one - https://lh6.googleusercontent.com/-533y ... _00135.jpg

If you are just wanting to get rid of the booster/servo there are a couple of ways it can be done without buying a complete pedal box and replumbing the car to a front rear split from the standard diagonal split.

1 innards of the booster/servo can be removed and replaced with a rod so the booster is still there but isn't doing anything - this was common on Gp N EVO rally cars.

2 Using a similar rod you can make up a spacer assembly to replicate the dimensions of the booster but leaving the master cylinder in its normal position - this is a homologated Gp N mod for the later EVO's. Like this - http://www.pro-tecmotorsport.com/partsD ... cfm?id=336

Author:  chch_mirage [ 23 Nov 2013 09:09 ]
Post subject:  Re: pedal box

http://www.rallynuts.com/user/products/ ... 33_600.jpg
hope that Link works this is wat I was Meaning Wat do you think.

Author:  Sack of Spuds [ 23 Nov 2013 21:12 ]
Post subject:  Re: pedal box

Unless your car is purely for track use and trailered to events I'd stay away from floor mounted pedal boxes with the cylinders pointing backwards. You'll be forever putting your feet on them and potentially damaging the plumbing. Ideally you'd want a false floor to hide them like a race car might have but it seem a lot of hassle when you could use a top mount one or even a servo replacement style kit like this - http://www.rallynuts.com/motorsport-bia ... -kiit.html.

Personally I like to keepfluid conections to a minimum inside the car so brake cylinders go under the bonnet. Brake fluid is the most dangerous fluid in a car (unless you run on ethanol), petrol is quite difficult to self ignite - brake fluid not so

Author:  chch_mirage [ 25 Nov 2013 21:14 ]
Post subject:  Re: pedal box

can get a cover to go over it so that's no prob, fluid shouldn't be a problem aslong as the connections are good
and supported, just an idea I was thinking about doing since you can run a balance bar and mount resivours else where

Page 1 of 1 All times are UTC + 12 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/